Use this when you want to add an effect to a specific band of the master sound.
As an example, follow the instructions below to apply BOOST SEND to the [MID] of the master sound.
1. Turn the channel rotary fader to play music from a channel.
2. Use the [BOOST LEVEL] switch to set the upper limit of the volume that can be adjusted with the Master Isolator.
3. Select an effect other than [HPF] with the SEND FX selection switch.
4. Set the Master Isolator [MID] knob to the right of 12 o'clock.
5. Press the [SEND] button above the knob to light it up.
6. Check that the indicator above the button is lit.
7. If the indicator is not lit, set the [MID] knob further to the right.
*Effects can also be added if steps 4 and 5 are interchanged.
Note: When the [BOOST LEVEL] switch is set to [+12], the volume may become loud, depending on how you move the Master Isolator.
*If the above procedure does not produce the effect, see the troubleshooting article below:
[The [SEND FX] effect does not work. Why?]
BOOST END

Articles

How do I use BOOST SEND?

What is BOOST SEND?
