3-BAND FX doesn't work. What should I do?
Check the settings as follows:
1. The [FX SOURCE INPUT, SMPLR] button is illuminated.
2. An effect is selected using the ISOLATE FX button.
3. One of the ISOLATE FX [LOW, MID, HI] knobs is set to a position other than center.
4. An effect is selected using the LEVER FX button.
5. One of the LEVER FX [LOW, MID, HI] levers is set to the [ON] or [HOLD] position.
6. The LEVER FX [SUB PARAMETER] knob is set to the appropriate position.
If no effect is observed at this point, it is possible that audio is not being input correctly to the unit or that the unit's output audio is not being routed correctly.
See [Connection] > [Connecting input/output terminals] in the Instruction Manual to check the unit is connected correctly. Also check the settings on your DJ mixer.
You can read the Instruction Manual here.
