The [SEND FX] effect doesn't work. Why?
Please follow the steps below.
■When [HPF] is selected with the SEND FX selector switch
1. Check that the [SEND] knob of the channel you want to filter is in the position where you get desired cutoff frequency.
2. Check that the [PARAMETER] knob is in the position where you get desired resonance setting.
Note : Depending on the frequency balance of the sound from the channel, the effect may not be applied or may be only slightly.
■When anything other than [HPF] is selected with the SEND FX selector switch
1. Check that the [SEND] knob of the channel you want to add effects to is in the position where you get desired sent signal level, or that the [SEND] button is lit and corresponding Master Isolator knob is set to right from the 12 o'clock position and the SEND indicator is lit.
2. Check that the TIME and [PARAMETER] knobs are in the proper position.
3. Check that the [RETURN LEVEL] knob is in the position where you get desired output level of effect signal.
4. If [EXT] is selected with the SEND FX selector switch, check that the external effects unit is properly connected.
